Refer to separate guideline (see Ventilation: volume targeted guideline)
This guidance is for babies where volume targeted modes cannot be used at the time
INTRODUCTION
Oxygenation
- Increase oxygenation by increasing:
- FiO2
- peak end expiratory pressure (PEEP)
- peak inspiratory pressure (PIP)
- inspiratory time (Tinsp)
CO2
-
Reduced by:
-
increased PIP
-
increased rate
-
occasionally by reducing excessive PEEP (beware of effect on oxygenation)
-
VENTILATOR PARAMETERS
PIP
-
Use lowest possible PIP to achieve visible chest expansion and adequate gas exchange on blood gas analysis
-
to minimise lung injury from barotrauma and inadvertent over-distension, avoid excessive PIP
-
need for higher pressures [e.g. mean airway pressure (MAP) >12 cm] could lead to consideration of high frequency oscillatory ventilation (HFOV) [see Ventilation: high frequency oscillatory ventilation (HFOV) guideline]
-
PEEP
- Use a PEEP ≥4 cm and increase incrementally up to 8 cm for improving oxygenation but when PEEP >6 cm necessary, take senior advice
Tinsp
- Usually between 0.3–0.4 sec
- Avoid Tinsp >0.5 sec except in term babies with parenchymal lung disease where a Tinsp up to 1 sec may be used
Rate
-
Fast-rate (≥60/min) ventilation is associated with fewer air leaks and less asynchrony compared to slow (20–40/min) rates
-
If rate >70/min required, HFOV may be a more appropriate option [see Ventilation: high frequency oscillatory ventilation (HFOV) guideline]
Flow
- Flow 5–8 L/min is generally sufficient
- Consider higher flows at faster ventilatory rates or shorter inspiratory times
- SLE ventilator has a fixed flow (5 L/min) that cannot be altered
Tidal volume (Vt)
- Target is 4–6 mL/kg
- Confirm that baby is receiving intended tidal volume before and after adjusting ventilation
SETTING UP VENTILATOR
- Switch on humidifier and follow manufacturer’s recommended settings for optimum temperature and humidity
Setting 1
-
When an admission of a preterm baby requiring ventilatory support (for recurrent apnoea, see Setting 2)
-
rate 60/min
-
PIP 16–18 cm H2O
-
PEEP 5 cm H2O
-
Tinsp 0.3–0.4 sec
-
FiO2 as required
-
flow 6–8 L/min (not applicable to SLE)
-
-
Adjust ventilatory settings depending on chest movement, SpO2, and measured Vt
-
Sample blood gas within 30 min of commencing ventilatory support
Setting 2
- For babies with normal lungs requiring supportive ventilation such as term babies with respiratory depression (asphyxia or drugs), babies with neuromuscular disorders or, in the post-operative period, and preterm babies with recurrent apnoea, set ventilator at following settings:
- rate 40/min
- PIP/PEEP 14–16/4 cm H2O
- Tinsp 0.35–0.4 sec
- FiO2 as required (often 0.21–0.3)
ADJUSTING VENTILATORY SETTINGS
Adjusting FiO2
- Oxygen is a drug and should be prescribed as with other medications. This should be done by specifying intended target range of SpO2 on baby’s drug chart
- Suggested target SpO2 ranges (see Oxygen saturation targets guideline)
- preterm babies: 91–95%
- term babies: generally 96–100% but adjust according to the pathology (see Persistent pulmonary hypertension of the newborn and Congenital heart disease: duct-dependent lesions guidelines)
Target PCO2
- Day 1–3: 4.5–8.5 kPa
- Day 4 onwards: 4.5–10 kPa
- If low PCO2 wean ventilation without delay and recheck within 1 hr of low measurement
Altering ventilatory settings according to blood gases
If blood gases are outside the targets, first check the following:
- Reliability of blood gas:
- is the blood gas result reliable?
- has there been a sudden unexpected change from previous blood gas values?
- did sample contain an air bubble?
- was it obtained from a poorly perfused site?
- Baby’s status:
- is baby’s chest moving adequately?
- how is the air entry?
- Ventilator and tubing
- is there an air leak? [transilluminate to exclude (see Transillumination of the chest guideline)
- what is the Vt?
- are the measured ventilatory values markedly different to the set ones?
- is there a large (>40%) endotracheal tube (ETT) leak?
- Small frequent changes are more appropriate than large infrequent ones
Blood gas scenario | Recommended action in order of preference |
Low PaO2/SpO2 |
|
High PaO2 |
|
High PaCO2 |
|
Low PaCO2 |
|
Low PaO2/SpO2 and high PaCO2 |
|
WEANING
- While weaning baby off ventilator:
- reduce PIP (usually by 1–2 cm) until MAP 7–8 cm reached
- thereafter, reduce rate to 20/min, usually in decrements of 5–10 breaths/min
Extubation
- Extubate babies <30 weeks’ gestation onto nasal CPAP or HFNC – for mode, (see Ventilation: Continuous positive airway pressure (CPAP)guideline or Ventilation: High-flow nasal cannulae (HFNC) guideline)
- more mature babies with no significant chest recessions can be extubated directly into incubator oxygen
BABIES FIGHTING VENTILATOR
If baby in asynchrony with the ventilator (fighting)
- Ensure baby is not hypoxic or under-ventilated
- Exclude blocked ETT
- Look for obvious pain e.g. necrotising enterocolitis
- If possible, change to synchronised form of ventilation (VTV/HFOV/SIMV)
- If sedation required, ensure it is adequate. Muscle relaxation seldom necessary and used only if IV morphine infusion (usually 10–20 microgram/kg/hr) already commenced
CARE OF VENTILATED BABY
Ventilated babies to have:
- Continuous electronic monitoring of heart rate, ECG, respiratory rate, SpO2 and temperature
- Transcutaneous monitoring can be useful in preterm babies on invasive ventilation who are clinically unstable. Discuss with consultant
- Blood pressure
- continuous measurement of arterial blood pressure in babies ≤28 weeks’ gestation, and those >28 weeks needing FiO2 >0.6
- cuff measurement 4-hrly in acute phase where arterial blood pressure not being measured
- ≥6-hrly blood gas (arterial or capillary) measurement during acute phase of disease
- Hourly measurement of colour, and measured ventilatory parameters. If sudden drop in Vt, check air entry
- Daily monitoring of intake, output and weight
PARENT INFORMATION
Offer parents the following information, available from: bliss.org.uk/parents/in-hospital/about-neonatal-care/equipment-on-the-unit-1